Objective of reversing mechanism in Spinning

When one complete layer has been wound on the bobbin, it is necessary to reverse the direction of the rail for the next layer. 

This is done automatically through the control of the “builder”. The more common mechanical means used for this purpose is a grasp of three bevel gears in the lay gearing train. 

Two large bevel gears are mounted on the same shaft in such a manner that with a short travel movement either of the two may be driven by the third, a small bevel gear. 

As one large bevel gear is driven from the left sideof the small bevel gear, one will cause the rail to descend.

What is Twist Per Inch or TPI or Turns Per Inch?

Twists per inch are the number of times the strand has been twisted in a one inch length. This is the method of designating twist in a roving.

Twists per inch are often called “turns per inch”. It is difficult to measure twist per inch in a roving, because it is generally quite low and the untwisted strand is weak.

The amount of twist to use varies with the staple of the cotton and the size of the roving into which it is being made.

Longer cotton requires less twist because individual fibres extend further in the strand and so help to bind themselves together more securely than do short fibres.

Finer roving needs more twist than coarse roving. As the strand becomes finer, the strength due to bulk alone decreases.

Also, as the fibres are drawn to be more nearly straight and parallel, there is less strength due to entangling with one another.  

How is the twist inserted in the roving?

Twisting is accomplished by the ‘flyer’ which is carried on the spindle. As the strand is delivered at the front rolls, it is led downward and forward to the top of the flyer, through the flier and on to the bobbin.

The flyer revolves rapidly and carries the roving around with it. The result is that the front roll is delivering a narrow ribbon of fibres in a fixed plane; the flyer, holding the other end of the exposed strand, turns rapidly and twists it.

The twist runs quickly up to the front roll as there is nothing to prevent. As rapidly as the front roll delivers a new length of ribbon, the flyer makes additional turns and they run back to the front roll.

For any given condition, the flyer speed and the front roll speed are fixed, which gives a constant ratio between the turns of twist and the inches delivered at the front roll. This is the “twist per inch”.