Classification of Knitting

Knitting is two types:

1. Warp Knitting
2. Weft Knitting

Weft Knitting is again two types:

1. Circular Knitting
2. Flat Knitting

Circular Knitting is again two types:

1. Single Jersey
2. Double Jersey


Warp and Weft Knitting

There are two major varieties of knitting: weft knitting and warp knitting. In the more common weft knitting, the Wales are perpendicular to the course of the yarn. In warp knitting, the wales and courses run roughly parallel. In weft knitting, the entire fabric may be produced from a single yarn, by adding stitches to each wale in turn, moving across the fabric as in a raster scan. By contrast, in warp knitting, one yarn is required for every wale. Since a typical piece of knitted fabric may have hundreds of wales, warp knitting is typically done by machine, whereas weft knitting is done by both hand and machine. Warp-knitted fabrics such as tricot and milanese are resistant to runs, and are commonly used in lingerie.



Maintenance of Knitting Machine

Knitting m/c needs to be maintained regularly for getting excellent performance of m/c and also maintain the proper quality of production. Maintenance for circular and flat bed knitting m/c is different.

There needed separate maintenance for different types of knitting machines.


Maintenance of Circular Knitting Machine:

1. Check out the m/c before starting the m/c.
2. Check out the yarn type, fabric type before starting the m/c.
3. Check out the fabric which is producing by the m/c.
4. Check out the m/c motor, belt, panel card.
5. Check out the m/c wheel.
6. Check out; is the roller pulling the produced fabric regularly?
7. Check out the fabric detector and needle detector.
8. Check the knot catcher.
9. If needle or sinker breaks, then submit the broken needle and take new one.
10. Remove the dust from the m/c.
11. Check out the m/c by Electrical and Mechanical operator.
12. Check the density of gear oil.
13. Input the new gear oil if finishes.


Maintenance of Flat Bed Knitting Machine:

1. Check out the m/c before starting the m/c.
2. Check out the yarn type, fabric type before starting the m/c.
3. Check out the fabric which is producing by the m/c.
4. Check the all automatic system of m/c.
5. Check the upper yarn of m/c.
6. Check the m/c needle.
7. Take care about needle marks, oil marks and oil spot.
8. Check the system when producing tipping collar.
9. Check the knit card, yarn count.
10. If needle breaks, submit the broken needle and take new one.


4 point system for detecting or calculating fabric faults

There need international standard quality inspection section in all knitting industry where the fabrics will be inspected by inspection m/c for detecting the faults and remark the fabric roll as grade A, B, C and R (Reject).

They are using 4 point system for detecting the fabric faults. There point and grade of fabric inspection are as below:
1. Up to 01 to 15 Point = “A” Class
2. Up to 16 to 20 Point = “B” Class
3. Up to 21 to 30 Point = “C” Class
4. More than  30 Point = “R” Class
(R=Reject)

N.B: Any Hole = 4 Point

Actual Grade Formula: Points*3302/Length (meter)*Width (inch)

Calculation Points/100 SQ. M = Total Points*39.37*100/Roll Length (m)*Actual Width (inch)